Current versions of the STL files for your Z-Temp products’ printed parts can be downloaded from these links:
Z-Temp and Bed Switch
The main housing should be printed "upside-down", in clear ABS, 190 or 200µ, no support.
- Main Housing v15 Octave transparent ABS.
- Control Knob Z-ABS
- Bed Switch Housing for 2016 4-position version (must print in PLA for tab strength, we use MeltInk or colorFabb)
- Bed Switch Knob Meltink PLA
- Bed Switch Housing 2015 On/Off version (must print in PLA for tab strength)
- Low-façade Extruder Cover for better visibility and access Print in any material.
- Snap-On Ribbon Cable Strain Relief We like colorFabb PLA/PHA for this
- Temperature Control Labels for All Ranges - print on your 2D printer, not 3D :)
- ColorTemp Label (png)
- ColorTemp Label (pdf)
Z-Sense
- Adjuster Knob - print in any color or material you like!
- Adjuster Bracket - we use carbon-fiber PLA for stiffness
- Switch Lever - we use CF PLA for this too, but it’s not critical
- PCB Tray - any material
- Mounting Setup for M300
Z-Mon
Z-LCD
- Housing Front We use (and love) 3Dfuel’s “Wound Up” coffee-based PLA for Z-LCD.
- Housing Rear
- Mounting Yoke