Z-Temp Products > Materials Compatibility

Semi Flex settings

(1/2) > >>

michael80:
Hello,
Could you please tell me how to print ninja flex SEMI FLEX ? It is very often under extruding...
But I did once. Now impossible to do it again. I have the ZT-HE Hot End and the 0.5 nozzle. 
Do you have any tips ?
Thank you by advance.

Michael.

Julia Truchsess:
I got it to print a single-wall spiral vase at 245º, 0.5mm nozzle, and 290µ layers. Did not do further testing since I don't really care for the stuff and Sainsmart TPU works and looks (imo) so much better.

Padraicsdad:
Sorry, I know it's no help but I took Julia's advice and bought Sainsmart TPU. It prints easy-peasy with Z-Temp and ZT-HE. Just wondering if Semi-flex is worth the pain when TPU is $25-ish on AZ. Good luck.

Julia Truchsess:
Be sure to use the "High Quality" setting for the slowest speed; I think they may have actually slowed it down a bit in the most recent Z-Suite versions. Also with Raftaway you can now get rid of the raft and get straight into your part so no need to deal with the problematic high extrusion rates called for during raft printing.

michael80:
Thank you very much ! I am going to try Sainsmart TPU.

Navigation

[0] Message Index

[#] Next page