Z-Temp Products > Materials Compatibility
Treed longchaine polyamide
(1/1)
hackerdaz:
Has anyone tried this material? I'm constantly having clogs whatever I try (different temps, larger nozzles).
Julia Truchsess:
I tried it once, using 0.4mm nozzle, 240º temp, and full bed heat. Extrusion was fine, but print was awful - very "melty" and bad warpage that lifted it from the bed.
hackerdaz:
Hi Julia,
Did you notice an uneven filament extrusion (see the attached photos)?
Also the treed support told me that the best temperature printing range is between 275-295°C!
Navigation
[0] Message Index
Go to full version