« previous next »
Pages: [1]

Author Topic: Treed longchaine polyamide  (Read 10893 times)

hackerdaz

  • Posts: 24
    • View Profile
Treed longchaine polyamide
« on: January 10, 2017, 07:12:05 PM »
Has anyone tried this material? I'm constantly having clogs whatever I try (different temps, larger nozzles).
Logged

Julia Truchsess

  • Administrator
  • Posts: 226
    • View Profile
Re: Treed longchaine polyamide
« Reply #1 on: January 16, 2017, 10:49:06 AM »
I tried it once, using 0.4mm nozzle, 240º temp, and full bed heat. Extrusion was fine, but print was awful - very "melty" and bad warpage that lifted it from the bed.
Logged
"Character is doing what's right when nobody's looking." - JC Watts Jr

hackerdaz

  • Posts: 24
    • View Profile
Re: Treed longchaine polyamide
« Reply #2 on: January 18, 2017, 05:00:41 PM »
Hi Julia,

Did you notice an uneven filament extrusion (see the attached photos)?
Also the treed support told me that the best temperature printing range is between 275-295°C!
Logged
Pages: [1]
« previous next »