« previous next »
Pages: [1]

Author Topic: Z-Sense Bed Height Sensor Now Available for Pre-Order!  (Read 15610 times)

Julia Truchsess

  • Administrator
  • Posts: 226
    • View Profile
Z-Sense Bed Height Sensor Now Available for Pre-Order!
« on: July 23, 2016, 11:12:50 PM »
Logged
"Character is doing what's right when nobody's looking." - JC Watts Jr

z-renegade

  • Posts: 41
    • View Profile
Re: Z-Sense Bed Height Sensor Now Available for Pre-Order!
« Reply #1 on: July 24, 2016, 05:09:01 AM »
Some days ago I thought I would not need it, but there are times when you prepare for a new print and wait for the printer has heated up and the door bell rings...

This is what I got.
Logged

Julia Truchsess

  • Administrator
  • Posts: 226
    • View Profile
Re: Z-Sense Bed Height Sensor Now Available for Pre-Order!
« Reply #2 on: July 24, 2016, 08:16:22 AM »
Hahaha!  ;D
Logged
"Character is doing what's right when nobody's looking." - JC Watts Jr

jwilfong

  • Posts: 4
    • View Profile
Re: Z-Sense Bed Height Sensor Now Available for Pre-Order!
« Reply #3 on: July 24, 2016, 10:10:09 PM »
I'm very excited about this new product. I use a product called BuildTak to increase adhesion of prints. The Zortrax hot end literally has to melt through the buildtax when starting a print. I'm sure this solve that issue.

Thanks!
Logged

Cicio

  • Posts: 16
    • View Profile
Re: Z-Sense Bed Height Sensor Now Available for Pre-Order!
« Reply #4 on: July 27, 2016, 12:03:57 PM »
ohh wonderful! It will also be useful for prints without a raft; It is getting enough empirical find the right thickness where to make the slices in Z-suite
Logged

NaotoSakaue

  • Posts: 25
    • View Profile
Re: Z-Sense Bed Height Sensor Now Available for Pre-Order!
« Reply #5 on: August 08, 2016, 12:10:49 AM »
Hi Julia.

Is it possible to adjust the gap for 1st layer using this?

N.Sakaue
Logged

Julia Truchsess

  • Administrator
  • Posts: 226
    • View Profile
Re: Z-Sense Bed Height Sensor Now Available for Pre-Order!
« Reply #6 on: August 08, 2016, 08:00:26 AM »
Quote from: NaotoSakaue on August 08, 2016, 12:10:49 AM
Is it possible to adjust the gap for 1st layer using this?

Yes, that is its purpose.
Logged
"Character is doing what's right when nobody's looking." - JC Watts Jr

DanielFaurb

  • Posts: 9
    • View Profile
¿Zortrax está considerando la posibilidad de utilizar la tecnología de impresión en masa? - Me gusta
« Reply #7 on: February 14, 2024, 08:27:51 AM »
¿Se puede solucionar el problema de las capas demasiado finas en la impresora ZT-HE de metal? - ¿Alguien ha encontrado una solución efectiva para corregir el problema de las capas demasiado delgadas en la impresora ZT-HE de metal de Zortrax?
Logged
Pages: [1]
« previous next »