So does the Z-Temp HE make it unable to use official Zortrax filament?

[JeX2]

I printed with grey Z-ABS and the Z-Suite v1.6.1 and with the firmware 1.0.3.  I used the ZT-HE nozzle. Other prints have the same issue. I will go back to firmware 0.0.8 and an older Z-Suite version and make some test. On the zortrax website only the oldes version you can get there is 1.3.0! Someone have an older version (e.g.  v1.2.1) and can give me that z-suite version? I can send that person my e-mail address in private message, so you can give me the z-suite in the e-mail attachment.

[Julia Truchsess]

Zortrax forum user Vyper has a complete dropbox archive of all Z-Suite and M200 firmware versions, but I can't find the link right now, I'll keep looking. It's on the forum somewhere...

[Padraicsdad]

Here's that link by VipeR: https://www.dropbox.com/sh/598b1gru0zxsnfw/AAAEiTsEcxnfIEfc44mMb5wYa?dl=0

[Julia Truchsess]

That dropbox has been disabled due to high traffic, but he posted another link if I remember correctly.

[JeX2]

I found a link to a Google Drive -> https://drive.google.com/drive/folders/0B8mSj86XjAMJSlhld2lyajdOTHc

All Firmwares and Z-Suite versions are there.

[Julia Truchsess]

Here is another archive of old software/firmware posted by Marcin of Zortrax:

https://cloud.zortrax.com:444/index.php/s/WqqD8xYYOxHpW4V