Messages

1

General Discussion / Re: Zortrax M200 Extruder Drive Gear

« on: December 27, 2018, 08:10:01 PM »

https://www.aliexpress.com/item/SWMAKER-1pcs-zortrax-M200-Extruder-drive-gear-feed-gear-3D-printer-spare-parts-accessories/32825665231.html?spm=a2g0s.9042311.0.0.63784c4dW5NHKN

Found it , At Aliexpress FYI. thanks anyways..

2

General Discussion / Zortrax M200 Extruder Drive Gear

« on: December 27, 2018, 01:53:11 PM »

Hello, Has anyone found a vendor that sells just the Extruder gear , I believe its 24T for the Zortrax M200 printer?

3

Materials Compatibility / Re: Best PLA filament

« on: March 25, 2017, 05:18:36 PM »

For PLA what Z-suite should one use and what fan percent should be used for the ones that obtain great prints with.
Thank you.

4

General Discussion / Re: DUAL Fan

« on: March 08, 2017, 02:17:05 PM »

Yes, I did add the new software.. Might go back to other version.. and see.. thanks...


Update::: I went back one version.. Fans now working to selection.. (not turning on when set to not to turn on)

5

General Discussion / Re: DUAL Fan

« on: March 08, 2017, 02:05:18 PM »

Hi, just installed the dual fan.. splice the other fan to the existing fan wiring.

Now when I print , I can see the 2nd fan  speeding at different times during the print. I have the fan setting 0% auto off.
Why is the fan still spinning? Zortrax M200

6

General Discussion / Shim .05

« on: February 15, 2017, 07:59:50 PM »

Hello, Is there some instructions on proper way to use the .05 shim with the z-temp setup? thanks