1
Is there any chance to add skirt? On raftless printing the skirt help a lot to extrude the filament for hold on the bed. It would be great to can add a skirt by the RaftAway.
User Forum
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussion / Z LCD
« on: March 27, 2017, 11:52:13 AM »
I got today the Z LCD. LCD on unpacking has view me some on display but as soon i putted it into my Z-Temp its tunred off. Now display view me nothing 
whats wrong there?
whats wrong there?
3
General Discussion / Re: DUAL Fan
« on: February 15, 2017, 09:44:27 AM »
i found yours on thingiverse. is the NF-A4x10 FLX 12V or 5V? I want replace all zortax fan with it
4
General Discussion / DUAL Fan
« on: February 15, 2017, 09:21:24 AM »
Has anyone a link for STL for Dual Fan support?
5
RaftAway / Re: Raftaway 1.1.0 Released, Adds Speed Multiplier
« on: February 14, 2017, 04:13:16 AM »
is Raftaway fully working latest Z Suite 1.7.2.1 and Firmware 1.0.5?
6
General Discussion / Z Suite 1.7.2.1 and Firmware 1.0.5
« on: February 14, 2017, 04:12:37 AM »
are all z-temp products working well with lattest Z Suite 1.7.2.1 and Firmware 1.0.5?
7
General Discussion / Re: filament holder TPU
« on: February 12, 2017, 02:24:50 PM »
yes, that what i have in mind but i look for a idea 
8
General Discussion / filament holder TPU
« on: February 11, 2017, 05:50:22 PM »
since i make my first prints with TPU i figured out a underextrude. i think that may the standard filament holder already makes not easy to rotate the spool. has anyone a good solution as alternative?
9
RaftAway / Re: Raftaway 1.1.0 Released, Adds Speed Multiplier
« on: February 11, 2017, 05:43:02 PM »
😲😲😲 can't wait to test my TPU 👏👏
10
RaftAway / Re: Raftaway 1.0.8 Released, Adds Extrusion Multiplier
« on: February 11, 2017, 05:37:49 PM »
yeah! a general setting for speed already would be nice! (since zortrax software only allow normal and fast) as example on TPU print it work already very well but should be a bit slower. btw raftaway its what i look since i got my zortrax 
great job!!
great job!!
11
RaftAway / Re: Raftaway 1.0.8 Released, Adds Extrusion Multiplier
« on: February 10, 2017, 03:36:33 AM »
Is there any chance to get update soon (print speed)? Specially on TPU printing make it much sense
Pages: [1]