1
General Discussion / Re: using flat printbeds with Z-Sense -> Buildtak instead of perfboard
« on: October 03, 2016, 02:32:17 AM »Quote
Doesn't make sense to me. You loose some heat because of the insulation of the perf board between the bed and BT (important for ABS only) and you loose leveling precision as the perf board tends to lift in the middle.
I've had excellent results. The first version of the perf board was very flexible. The second version was a lot stiffer. My Zortrax was shipped with a warped heat bed. Fought that for a long time and finally ordered a new one. It is perfectly flat and now using BT with Z-Sense is a pure pleasure. My models adhere incredibly well to BT. I have had some models that pulled the BT off the perf board due to shrinkage but the model stayed adhered to the BT. I have had models that the BT stayed firmly on the perf board and the print firmly to the BT but the walls of the model itself separated.
I will definitely try your method.