1
General Discussion / Zortrax M200 Extruder Drive Gear
« on: December 27, 2018, 01:53:11 PM »
Hello, Has anyone found a vendor that sells just the Extruder gear , I believe its 24T for the Zortrax M200 printer?
User Forum
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussion / Shim .05
« on: February 15, 2017, 07:59:50 PM »
Hello, Is there some instructions on proper way to use the .05 shim with the z-temp setup? thanks
Pages: [1]