1
General Discussion / Heat bed connector cable crimps
« on: May 19, 2017, 05:57:35 AM »
Does anyone know the size of the crimps which are used in the large connector?
User Forum
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Materials Compatibility / Mechanical strength of various materials
« on: April 09, 2017, 01:53:40 PM »
Posting results from tensile tests for 8 materials, mainly filled or modified. Tensile specimens printed using m200, 0.19 height, high infill. Tested but not shown is Black Magic (graphene filled), difficult to print, had to preheat the filament in order to use it without breaking, but in terms of mechanical strength is around 0.7kN at 1mm of displacement, then it brakes. The middle cross-section of the specimens is 4X10mm^2.
3
Materials Compatibility / Treed longchaine polyamide
« on: January 10, 2017, 07:12:05 PM »
Has anyone tried this material? I'm constantly having clogs whatever I try (different temps, larger nozzles).
4
General Discussion / Extruder connectors
« on: August 12, 2016, 10:57:56 AM »
Hi all,
During the mounting of the dual fan, the crimp of one of the cables (I think this one goes to the hot end) broke. Can someone inform me about the name of the connector in order to search for an appropriate crimp?
During the mounting of the dual fan, the crimp of one of the cables (I think this one goes to the hot end) broke. Can someone inform me about the name of the connector in order to search for an appropriate crimp?
Pages: [1]