1
RaftAway / Re: Error when Removing Raft with Shell Infill
« on: February 15, 2017, 02:01:23 PM »
Awesome--thanks for all of your work on this!
User Forum
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
RaftAway / Re: Error when Removing Raft with Shell Infill
« on: February 15, 2017, 10:38:46 AM »
Sure thing. Here's a simple test file (just a star profile for layer adhesion testing): http://s000.tinyupload.com/index.php?file_id=02422253722900855277
I've tried multiple wall thicknesses, spiral enabled/disabled, and nothing seems to make a difference. However, as soon as I add the floor back, then it works. But I wouldn't think that the skirt line should disappear because of that, should it?
I've tried multiple wall thicknesses, spiral enabled/disabled, and nothing seems to make a difference. However, as soon as I add the floor back, then it works. But I wouldn't think that the skirt line should disappear because of that, should it?
3
RaftAway / Error when Removing Raft with Shell Infill
« on: February 14, 2017, 06:16:45 PM »
Hope this is the right spot for this question...
First off, love my Z-Temp and I'm grateful to have access to the RaftAway tool! However, I've noticed an odd behavior in the last few versions of RaftAway that I've tested. When trying to remove the raft from a model printed with Shell infill, I get an error that says "No Raft found." This only seems to happen when I disable printing of the bottom surface, and it happens regardless of the number of wall layers chosen. Any thoughts as to why this might be happening? Thanks!!
First off, love my Z-Temp and I'm grateful to have access to the RaftAway tool! However, I've noticed an odd behavior in the last few versions of RaftAway that I've tested. When trying to remove the raft from a model printed with Shell infill, I get an error that says "No Raft found." This only seems to happen when I disable printing of the bottom surface, and it happens regardless of the number of wall layers chosen. Any thoughts as to why this might be happening? Thanks!!
Pages: [1]