Z-Temp Forum
Z-Temp Products => News and Announcements => Topic started by: Julia Truchsess on July 23, 2016, 11:12:50 PM
-
http://www.z-temp.co/products/z-sense-bed-height-sensor.html
-
Some days ago I thought I would not need it, but there are times when you prepare for a new print and wait for the printer has heated up and the door bell rings...
This is what I got.
-
Hahaha! ;D
-
I'm very excited about this new product. I use a product called BuildTak to increase adhesion of prints. The Zortrax hot end literally has to melt through the buildtax when starting a print. I'm sure this solve that issue.
Thanks!
-
ohh wonderful! It will also be useful for prints without a raft; It is getting enough empirical find the right thickness where to make the slices in Z-suite
-
Hi Julia.
Is it possible to adjust the gap for 1st layer using this?
N.Sakaue
-
Is it possible to adjust the gap for 1st layer using this?
Yes, that is its purpose.
-
¿Se puede solucionar el problema de las capas demasiado finas en la impresora ZT-HE de metal? - ¿Alguien ha encontrado una solución efectiva para corregir el problema de las capas demasiado delgadas en la impresora ZT-HE de metal de Zortrax?