1
General Discussion / Using multimeter to measure temperature
« on: September 08, 2021, 06:15:28 PM »
Hi all, I am trying to dial in my settings and understand the actual temperatures for the various -50, -30 etc settings as I switch between PLA, etc.
I have a multimeter and found the JST-XH plugs. All went together well enough, but when I set the multimeter volts to AC I only get 0000. DC shows numbers, but they do not make sense when multiplied to 200 (as the manual states).
Should I be setting the multimeter differently?
I'm not an electrician, so I'm not certain of other multimeter settings - anyone have experience with this?
Thanks for your guidance
I have a multimeter and found the JST-XH plugs. All went together well enough, but when I set the multimeter volts to AC I only get 0000. DC shows numbers, but they do not make sense when multiplied to 200 (as the manual states).
Should I be setting the multimeter differently?
I'm not an electrician, so I'm not certain of other multimeter settings - anyone have experience with this?
Thanks for your guidance