Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - nrobb

Pages: [1]
1
Materials Compatibility / PTFE or all metal HE with Colorfab Copperfill
« on: January 11, 2018, 05:39:46 AM »
I am looking into printing with Colorfab Copperfill. The colorfab site suggests using an all metal hot end due to the increased friction of the filament, while the Z-Temp site says the all metal hot end should not be used for PLA. Which hot end would be best. Thanks

Pages: [1]