Show Posts
1
Materials Compatibility / PLA raft removal
« on: October 22, 2016, 01:12:34 PM »
Hello,
New customer here. I have a quick question regarding the removal of rafts from PLA prints in general. I did a print overnight using eSun PLA PRO and the v2 nozzle, using the provided shim (see pictures). And while the print came out ridiculously good at 0.9 layer height, the raft doesn't want to crisply break off like I expected.
I just realized that I used Z-suite 1.7.0, and that 1.6.x is the supported version. Anyways, it works great with the Z-ABS profile and -40 on the z-temp.
Any raft tips appreciated, thanks.
New customer here. I have a quick question regarding the removal of rafts from PLA prints in general. I did a print overnight using eSun PLA PRO and the v2 nozzle, using the provided shim (see pictures). And while the print came out ridiculously good at 0.9 layer height, the raft doesn't want to crisply break off like I expected.
I just realized that I used Z-suite 1.7.0, and that 1.6.x is the supported version. Anyways, it works great with the Z-ABS profile and -40 on the z-temp.
Any raft tips appreciated, thanks.