Z-Temp Forum
Z-Temp Products => Materials Compatibility => Topic started by: hackerdaz on January 10, 2017, 07:12:05 PM
-
Has anyone tried this material? I'm constantly having clogs whatever I try (different temps, larger nozzles).
-
I tried it once, using 0.4mm nozzle, 240º temp, and full bed heat. Extrusion was fine, but print was awful - very "melty" and bad warpage that lifted it from the bed.
-
Hi Julia,
Did you notice an uneven filament extrusion (see the attached photos)?
Also the treed support told me that the best temperature printing range is between 275-295°C!