Messages

1

RaftAway / Re: Raftaway 1.0.8 Released, Adds Extrusion Multiplier

« on: February 06, 2017, 02:57:48 PM »

I'd also suggest to only allow decreasing of the speed as increasing speeds may have undesired effects. So let's say I could add a "Speed factor" with a default of 100% which could be decreased down to 50%.

soud good!

Nextor

2

RaftAway / Re: Raftaway 1.0.8 Released, Adds Extrusion Multiplier

« on: February 06, 2017, 04:49:28 AM »

Hello to all!

This is a amazing software! Very cool! 

I have a question like additive3d.
Is it possible change print speed? I don't need a specific control of speed (40 mm/s), to me just a multiplier of basic speed.
With low speed I can print TPU with low shore (70 shore A).

Nextor