Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AstroBuilder

Pages: [1]
1
Materials Compatibility / Re: Ultem - Apparently the Stiffest Material Available
« on: August 31, 2016, 09:14:04 AM »
Julia,

Thanks for the knowledgeable reply.  I will outfit my M200 with the Z-Temp products, but pursue other alternatives for a printer that can handle Ultem.

Thanks again.


Dennis

2
Materials Compatibility / Ultem - Apparently the Stiffest Material Available
« on: August 27, 2016, 01:45:47 PM »
Has anyone tried or thought about printing with Ultem 1010?  It's apparently the stiffest material available today and would bring the M200 up into the ranks of a Stratasys.  Would the Z-Temp products enable doing so?




Pages: [1]