Messages

1

General Discussion / Re: ZT-HE from french reseller, no "z-temp" name written on it

« on: September 25, 2020, 10:47:53 AM »

Thank you, it was not written on the french reseller website.

2

General Discussion / ZT-HE from french reseller, no "z-temp" name written on it

« on: September 25, 2020, 06:51:06 AM »

Hello,

As written in the title, I ordered a ZT-HE from a french reseller, and there is no "z-temp" written on it like my old one ordered from official website...

Does it happens or it is not a real ZT-HE ?

Thank you.

Best regards

3

General Discussion / ZT-HE All Metal layer too thin ?

« on: February 14, 2020, 08:52:02 AM »

Hello,

I just bought a ZT-HE All Metal with block insulator kit to replace the Default V2 I had.

I just printed with it the same zcode I already did the the V2, and I have a "little" issue with the result :

The top layer has some holes as you can see on the picture.


The layers does not seems to fix well on top of each other too :


Zcode with Z-suite, the printer is completly stock exept ZT-HE, Filament is black Z-ABS original...
Is there something wrong ?

I thought a a ZT-HE all metal would be better than the stock one for Z-ABS and Z-ULTRAT

Thank you.
Best regards