Z-Temp Forum
Z-Temp Products => General Discussion => Topic started by: hdi27 on May 31, 2018, 08:43:12 AM
-
Hello,
Someone know if Z-Temp works with the new Zortrax M200 Plus and the Hot-End V3 ?
Thanks !
Hadrien.
-
We don't have an M200 Plus here, so I'm working from pictures and hearsay at this moment.
ZT-HE: Looks like it should work.
Z-Sense: Looks like it won't work out-of-the-box due to the new bed connector design and probably mounting issues.
Z-Temp ZTC-200: No idea.
Z-Mon: No idea, but since the printer has its own runout detector, it's pretty moot.
If any M200 Plus owners or experts has further info, please chime in, thanks!
Julia
-
Hello !
I've got the M200 Plus now, and the Z-Temp: It's works !
No differences between M200 and M200 Plus to mount Z-Temp on it. I take the printed part who was mounted on my M200, and it fit exactly as on the M200.
I don't try yet to mount Z-sense, but it seems to be more complicated.
Maybe if I'm soldering a JST cable on the "Pogo pins" ?
Hadrien
-
Thank you for reporting, great to know!
-
I tried Z-Temp with M200 plus today, and the printer didn't turn on when the z-temp was mounted on the extruder and the extruder cable was in the z-temp socket. However, when I disconnected the extruder cable, the printer booted normally. I'm wondering what is the problem. I would be grateful for more successful reports of running m200+ with the Z-Temp.
-
What temperature offset is the Z-Temp set to when you turn on the printer?
Is the Z-Temp known to be good, i.e. has it been tested with an M200?
-
We have just tried it on M200, also doesn't work - seems that the unit is broken. I haven't used it for a while so it's possible.
-
If it is defective please write to info@z-temp.co, thanks.