« previous next »
Pages: [1]

Author Topic: DUAL Fan  (Read 11181 times)

delaire

  • Posts: 11
    • View Profile
DUAL Fan
« on: February 15, 2017, 09:21:24 AM »
Has anyone a link for STL for Dual Fan support?
Logged

delaire

  • Posts: 11
    • View Profile
Re: DUAL Fan
« Reply #1 on: February 15, 2017, 09:44:27 AM »
i found yours on thingiverse. is the NF-A4x10 FLX 12V or 5V? I want replace all zortax fan with it
Logged

Julia Truchsess

  • Administrator
  • Posts: 226
    • View Profile
Re: DUAL Fan
« Reply #2 on: February 15, 2017, 07:31:09 PM »
All M200 fans are 12V.
Logged
"Character is doing what's right when nobody's looking." - JC Watts Jr

hridge10

  • Posts: 6
    • View Profile
Re: DUAL Fan
« Reply #3 on: March 08, 2017, 02:05:18 PM »
Hi, just installed the dual fan.. splice the other fan to the existing fan wiring.

Now when I print , I can see the 2nd fan  speeding at different times during the print. I have the fan setting 0% auto off.
Why is the fan still spinning? Zortrax M200
Logged

Julia Truchsess

  • Administrator
  • Posts: 226
    • View Profile
Re: DUAL Fan
« Reply #4 on: March 08, 2017, 02:11:03 PM »
The fan(s) have always run at the end of the raft, presumably in order to make raft removal easier. There has also been a lot of discussion on the Zortrax forum lately about Z-Suite 1.8.x doing crazy things and overriding manual fan speed settings, but I haven't used 1.8x myself (for that very reason) so can't comment.
« Last Edit: March 08, 2017, 02:24:54 PM by Julia Truchsess »
Logged
"Character is doing what's right when nobody's looking." - JC Watts Jr

hridge10

  • Posts: 6
    • View Profile
Re: DUAL Fan
« Reply #5 on: March 08, 2017, 02:17:05 PM »
Yes, I did add the new software.. Might go back to other version.. and see.. thanks...


Update::: I went back one version.. Fans now working to selection.. (not turning on when set to not to turn on)
« Last Edit: March 08, 2017, 02:38:37 PM by hridge10 »
Logged
Pages: [1]
« previous next »