1
General Discussion / Help! I'm new to the ZT-HE
« on: August 11, 2019, 03:24:08 PM »
I am attempting to successfully install my new ZT-HE on my M200. I've followed the directions to the best of my ability, I've cleaned the apparatus of any residual PLA.
When I load material into the ZT-HE, it appears to be feeding it through fine but then I get the clicking noise and zero extrusion. Would this indicate improper installation? Or would something else potentially be causing me problems.
When I load material into the ZT-HE, it appears to be feeding it through fine but then I get the clicking noise and zero extrusion. Would this indicate improper installation? Or would something else potentially be causing me problems.