Messages

1

General Discussion / Re: Help! I'm new to the ZT-HE

« on: August 12, 2019, 09:08:11 PM »

Thank you Julia, I'll give it a try. I ordered a replacement motor after breaking the previous one while trying to do maintenance so I am out of commission for a few day. Will reattempt the ZT-HE when it arrives, I'm quite excited to give it a whirl. Printing with PLA using the Zortrax hardware is a drag and I have very large architectual builds that I am dealing with.

2

General Discussion / Re: Help! I'm new to the ZT-HE

« on: August 12, 2019, 08:49:09 PM »

Hi Julia,

Here's what I ordered from you. I think it might not be the hot end but rather the motor. I'm going to order a replacement motor to see if that solves the issue.

ZT-HE Hot End
SKU: #ZT-HE

Feed Tube: PTFE insert, standard for ≤ 250º (all materials)
2 × $99.00

3

General Discussion / Help! I'm new to the ZT-HE

« on: August 11, 2019, 03:24:08 PM »

I am attempting to successfully install my new ZT-HE on my M200. I've followed the directions to the best of my ability, I've cleaned the apparatus of any residual PLA.

When I load material into the ZT-HE, it appears to be feeding it through fine but then I get the clicking noise and zero extrusion. Would this indicate improper installation? Or would something else potentially be causing me problems.