Z-Temp Forum

Z-Temp Products => General Discussion => Topic started by: frosty19 on August 04, 2016, 05:50:58 AM

Title: New software and firmware temperatures?
Post by: frosty19 on August 04, 2016, 05:50:58 AM

Hi, Can you update current profile temperatures from Z-Suite 1.6.1 and firmware 1.0.4 ?
Can you also add profile temperatures for PCABS? Im interested in printing from PC (Orbitech) but I'm not sure which profile should I use.

Also it would be great if you could add bed temps and everything in one place like here:

http://www.z-temp.co/support/z-suite-nominal-profile.html

Title: Re: New software and firmware temperatures?
Post by: Julia Truchsess on August 05, 2016, 09:07:37 AM

Sorry, I've been super-busy and have not had time to do this yet. I use only Z-ABS profile, and that has not changed from its usual 275º in 1.6.1.

It's easy to test the temp yourself using the monitor output of Z-Temp and a voltmeter - multiply the voltage by 200 and you get degrees C. The temperature almost always overshoots at print launch, and it will drop when the fans come on after the raft, but in mid-print it will be stable unless using Auto fan.