Messages

1

General Discussion / Re: Z-Temp Model 2015 Software Compatibility

« on: June 01, 2016, 01:21:03 PM »

Ah, I couldn't have seen the picture in your post when I read it because I wasn't logged in. Logged in and responded to the post still without seeing it with the top "Reply" button.

Knob removed.

2

General Discussion / Re: Z-Temp Model 2015 Software Compatibility

« on: June 01, 2016, 12:29:03 PM »

Thanks Julia. How do I remove the knob from the rotary switch? I am afraid that I will damage the rotary switch if I try to pull it off. And when I remove it, how do I know in which position I have to put it before I install the knob back on?

3

General Discussion / Z-Temp Model 2015 Software Compatibility

« on: June 01, 2016, 09:03:55 AM »

Quoted from Legacy Manual for Z-Temp 2015 Model:

The Z-Temp™ is warranted to perform as described when used as specified herein with the
M200 printer together with Z-Suite 1.0 or earlier and M200 firmware 0.0.5 or earlier

What can I do to make my Z-Temp Model 2015 and bed heater switch compatible with the latest firmware?