Show Posts
1
Materials Compatibility / Nylon printing
« on: December 23, 2016, 09:49:40 AM »
Hello,
I just installed a Z-temp (and Z-bed), i hoped it would help to print with nylon (Taulman bridge) material...
Does someone as good results with this material? the raft print very fine, then few minutes later, the wire stop coming (the motor wheel slide on the nylon wire)
The raft easily come out from the heat-bed, but is impossible to remove from the printed part.
Am i losing time when trying to use nylon? or someone did manage to obtain good results?
Thank you for your answers.
vincent
I just installed a Z-temp (and Z-bed), i hoped it would help to print with nylon (Taulman bridge) material...
Does someone as good results with this material? the raft print very fine, then few minutes later, the wire stop coming (the motor wheel slide on the nylon wire)
The raft easily come out from the heat-bed, but is impossible to remove from the printed part.
Am i losing time when trying to use nylon? or someone did manage to obtain good results?
Thank you for your answers.
vincent