Topics

1

Materials Compatibility / Colorfabb nGen

« on: July 08, 2016, 05:53:55 AM »

Hello,

I must show you some good results with my colorfabb nGen prints. My settings are:

• Z-ABS - 40°C (235°C)
• 90-140 microns
• single fan/ fan speed: auto
• ZT-HE Hot End
• Raft layers heatbed on, then off (position 3 -> 0)

2

Materials Compatibility / Colorfabb woodfill

« on: June 18, 2016, 06:18:11 AM »

Hello,
I ordered woodfill yesterday. I had read from the colorfabb website that woodfill must print with a layerhight between 0.29 mm and 0.25mm. Have some one made experience with this filament? Can I print under 0.2mm layerhight?

3

General Discussion / Unload problem, filament get stuck

« on: June 10, 2016, 02:22:00 AM »

Hello,

I have a problem with the unload procedure. The filament get stuck in the feederwheel. It happens because at the end of the filament is a blob. So it is to big for the upper feeder hole. I can upload a picture when I am at home. I use the firmware 1.03 (240°c). I had use Z-ABS (grey) and ABS (green).