Messages

1

General Discussion / Re: So does the Z-Temp HE make it unable to use official Zortrax filament?

« on: July 26, 2016, 06:37:14 AM »

I found a link to a Google Drive -> https://drive.google.com/drive/folders/0B8mSj86XjAMJSlhld2lyajdOTHc

All Firmwares and Z-Suite versions are there.

2

General Discussion / Re: So does the Z-Temp HE make it unable to use official Zortrax filament?

« on: July 25, 2016, 02:36:41 AM »

I printed with grey Z-ABS and the Z-Suite v1.6.1 and with the firmware 1.0.3.  I used the ZT-HE nozzle. Other prints have the same issue. I will go back to firmware 0.0.8 and an older Z-Suite version and make some test. On the zortrax website only the oldes version you can get there is 1.3.0! Someone have an older version (e.g.  v1.2.1) and can give me that z-suite version? I can send that person my e-mail address in private message, so you can give me the z-suite in the e-mail attachment.

3

Materials Compatibility / Colorfabb nGen

« on: July 08, 2016, 05:53:55 AM »

Hello,

I must show you some good results with my colorfabb nGen prints. My settings are:

• Z-ABS - 40°C (235°C)
• 90-140 microns
• single fan/ fan speed: auto
• ZT-HE Hot End
• Raft layers heatbed on, then off (position 3 -> 0)

4

Materials Compatibility / Re: Colorfabb woodfill

« on: June 24, 2016, 10:07:14 AM »

I give up and  will sale the filament. I don't want to modify my extruder. I will give Polymaker Polywood a try. Thank you for your advice Julia!

5

Materials Compatibility / Re: Colorfabb woodfill

« on: June 23, 2016, 07:16:17 AM »

So i made my first Tests. The results were not good. It seems that the feeder gear don't grap the filament enough. Because of that the filament don't extrude to the nozzle -> hotend was printing in the air.  But when i pushed the filerment with my fingers it extruded again. I try to replace the extruder gear with a mk8 gear. Hope it grap the filament better.

6

Materials Compatibility / Colorfabb woodfill

« on: June 18, 2016, 06:18:11 AM »

Hello,
I ordered woodfill yesterday. I had read from the colorfabb website that woodfill must print with a layerhight between 0.29 mm and 0.25mm. Have some one made experience with this filament? Can I print under 0.2mm layerhight?

7

General Discussion / Unload problem, filament get stuck

« on: June 10, 2016, 02:22:00 AM »

Hello,

I have a problem with the unload procedure. The filament get stuck in the feederwheel. It happens because at the end of the filament is a blob. So it is to big for the upper feeder hole. I can upload a picture when I am at home. I use the firmware 1.03 (240°c). I had use Z-ABS (grey) and ABS (green).

8

Materials Compatibility / Re: Willow Flex bio degradable flexible filament

« on: June 01, 2016, 08:22:49 AM »

Do you use a shim?