1
General Discussion / Re: Heat bed connector cable crimps
« on: May 19, 2017, 10:12:41 AM »
Found the info on zortrax forum. Thanks!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
What settings and material?
I had tested from 125 to 500+% with .19 and .39 layer heights with z-abs, normal speed, low infill. Version 1.8.1 and 1.8.2
From left to right. 100%, 125%, 150%, 225%, 337.5%
http://imgur.com/5pFH4wZ
I measured 17.9285g (reference), 17.9233g (+25), 17.8598g (+25).