1
Materials Compatibility / Re: Nanodax Glass-Wool-Filled-Polypropylene
« on: September 19, 2016, 04:19:43 AM »
I would like to try your filament @ Mr. Sakaue.
When is it going to be released ?
When is it going to be released ?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I doubt that higher infill will fix layer splitting. If ABS wants to warp, it will find a way.
Two days after i ordered from Julia the reseller got added.
Yes that is true
But the reseller did not have stock until more than 3 weeks after your order shipped