Messages

1

Materials Compatibility / Re: France filament good deal

« on: June 14, 2016, 04:04:40 AM »

You are right, the raft is sometimes difficult to remove, I will try to level the temperature.

Thx for the advice.

Philippe

2

Materials Compatibility / France filament good deal

« on: June 13, 2016, 05:18:31 PM »

For European, I have found and tested a great deal for abs. It print nice with z-abs -10 offset.

http://www.filament-abs.fr/produit/pack-couleurs-10-bobines-filaments-abs/

Ten roll for 189€, and no, I don't work for them..

Hope this help someone.

Philippe

3

Materials Compatibility / Re: Saintsmart TPU

« on: June 11, 2016, 12:17:23 PM »

OK, Got it! The screw on the extruder gear was loose and at some time it stopped to turn giving the look of a blocked filament.

First TPU part is printing right now.

Thx to all of you.

Philippe

4

Materials Compatibility / Re: Saintsmart TPU

« on: June 09, 2016, 07:35:03 PM »

I try to use the same orange as you..

5

Materials Compatibility / Re: Saintsmart TPU

« on: June 07, 2016, 04:56:39 PM »

Thx, I will try again, I have a V4 but I don't see why It wouldn't work for me.. Beside my two left hands:)

Phil

6

Materials Compatibility / Saintsmart TPU

« on: June 06, 2016, 07:04:25 PM »

Can someone explain how to load flexible filament such as Saintsmart TPU?

I tried but it jammed and blocked the extruded, I have had to disassemble the extruded to remove the filament.

Thanks for your help

Philippe

7

News and Announcements / Re: Welcome to the new Z-Temp Forum!

« on: May 31, 2016, 04:07:44 AM »

Hi There, really happy to get e dedicated forum, long life to Z-Temp!

Philippe