Z-Temp Products > Materials Compatibility

France filament good deal

(1/1)

pri:
For European, I have found and tested a great deal for abs. It print nice with z-abs -10 offset.

http://www.filament-abs.fr/produit/pack-couleurs-10-bobines-filaments-abs/

Ten roll for 189€, and no, I don't work for them..

Hope this help someone.

Philippe

Julia Truchsess:
I usually print "generic" ABS at 235 - 240º. 265º (Z-ABS profile -10º) seems really hot, probably resulting in difficult raft and support removal.

z-renegade:

--- Quote from: pri on June 13, 2016, 05:18:31 PM ---http://www.filament-abs.fr/produit/pack-couleurs-10-bobines-filaments-abs/

--- End quote ---

I did test their filament and found it to be no good. The UL listed one turned out to distribute toxic fumes in the house (it stinks terrible) and the regular ABS for wich I got some samples did not show good print results. I prefer to look for good priced NuNus ABS or PrimaABS on Amazon wich are in the same Range (below 20 Euros / KG without the need to order 10 spools) and provide same or better print results.

pri:
You are right, the raft is sometimes difficult to remove, I will try to level the temperature.

Thx for the advice.

Philippe

Navigation

[0] Message Index