Z-Temp Products > Materials Compatibility

Saintsmart TPU

(1/2) > >>

pri:
Can someone explain how to load flexible filament such as Saintsmart TPU?

I tried but it jammed and blocked the extruded, I have had to disassemble the extruded to remove the filament.

Thanks for your help

Philippe

Julia Truchsess:
Sainsmart TPU has worked for me every time on my v1 and v3 M200s. I use a 0.4mm nozzle and 235 - 245º extrusion temperature, never any wrapping on the gear. I've had reports of success from other users as well.

Other TPU/TPE materials from Ninja, Fila, TreeD, and eSun have had problems with wrapping around the gear, but Sainsmart has been a winner for me.

Cicio:
I'm using the Kyoto flex TreeD filaments, with nozzle 0.5, no problem with the gear, I have to try to use the nozzle 0.4.
The filament is normally loaded, for now no problem.

pri:
Thx, I will try again, I have a V4 but I don't see why It wouldn't work for me.. Beside my two left hands:)

Phil

Julia Truchsess:
Which color(s) are you using? I've only tried yellow, orange, and red. I did use clear "FlexSolid" from MadeSolid and it worked too, but print quality didn't seem as good as Sainsmart.

Navigation

[0] Message Index

[#] Next page